[PR]上記の広告は3ヶ月以上新規記事投稿のないブログに表示されています。新しい記事を書く事で広告が消えます。
one. Dimension D will not contain mildew flash, protrusions or gate burrs. Mould flash, protrusions or gate burrs shall not exceed 0.fifteen mm per stop.
Dimension E1 would not involve interlead flash or protrusion.Interlead flash or protrusion shall not exceed 0.15 mm for every aspect.
2.The deal leading may possibly be scaled-down when compared to the offer base. Dimensions D and E1 are determined for the outermost extremes of your plastic system exclusive of mould flash, tie bar burrs, gate burrs and interlead flash, but including any mismatch between the best and base of your plastic overall body.
3.These dimensions implement to your flat part on the guide involving 0.08 mm and 0.fifteen mm in the guide suggestion.
4.Dimension "b" will not incorporate dambar protrusion. Allowable dambar protrusion shall be 0.08 mm total in extra of your "b" dimension at utmost product situation.
The dambar are not able to be located about the decrease radius with the foot.Bare minimum space in between protrusion and an adjacent guide shall not be less than 0.07 mm.
The last address accessed during the last read or write operation, incremented by one. Thisaddress stays valid between operations as long as the chip power is maintained.
Theaddress “roll over” during read is from the last byte of the last memory page to the firstbyte of the first page.
The address “roll over” during write is from the last byte of the cur-rent page to the first byte of the same page.Once the device address with the read/write select bit set to “1” is clocked in andacknowledged by the EEPROM, the current address data word is serially clocked out.
The microcontroller does not respond with an input “0” but does generate a followingstop condition.Current Address ReadRANDOM READ: A random read requires a “dummy” byte write sequence to load in thedata word address.
Once the device address word and data word address are clockedin and acknowledged by the EEPROM, the microcontroller must generate another startcondition. The microcontroller now initiates a current address read by sending a deviceaddress with the read/write select bit high.
The EEPROM acknowledges the deviceaddress and serially clocks out the data word. The microcontroller does not respondwith a “0” but does generate a following stop condition.